Troubleshoot Netgear Genie Continually Appearing After Installation
Though Netgear is one of the best brands for satisfying WiFi needs, it also is prone to some glitches. Among all, Netgear Genie continually appearing after installation is the most reported issue. If you are also facing the same problem with your Netgear extender, then this troubleshooting guide is going to help.
Netgear Genie continually appearing after installation issue can occur if your Netgear extender is not being set up in a correct manner. Or, the WiFi device might have disconnected from your home WiFi router’s network.
Here’s how to troubleshoot Netgear Genie continually appearing after installation.
- First and foremost, power cycle your extender by unplugging it and plugging it back in after some time.
- Disconnect your extender from the Netgear range extnetwork and reconnect it.
- Reboot the web browser you are using to access the Netgear Genie Setup wizard.
- Update your web browser to the latest software version. If the clutter of cache, cookies, and browsing history is also packed there, consider removing it.
- Type the mywifiext web address again and make sure there are no typing error within that.
If the same issue is still making you annoyed, you are advised to reset the Netgear extender back to the default settings. You can reset the device by pressing the physical Reset button. Once done, set up the device again for accessing the Netgear Genie Setup wizard.
Just in case Netgear Genie still continues to appear, try to get in touch with an expert technician for quick help.
Bonus!
1. Change the Extender’s Location
Table of Contents
Changing the location of your Netgear extender may also help you get rid of the issue. Place the extender within the signal range of your WiFi router. It must receive at least 40% of your home WiFi router’s signal strength.
While relocating your extender, keep in mind to place it away from the device that may cause signal interference. For instance, avoid placing it near microwave ovens, Bluetooth speakers, refrigerators, baby monitors, fish tanks, garage openers, aluminum studs, metal appliances, concrete walls, cellular phones, etc.
2. Check the Wired Connections
Perhaps, there is some issue with the wires you have used to connect your router and extender. Check all the wired connections and make sure that all the wires are properly installed as well as are finger-tight.
In case of any breakage in a cable, consider replacing it with a new one. Once done, try to access the Netgear extender login page and check if it helps you resolve the issue or not.
Must Read| how much filler is in one piece
3. Update the Firmware
If your Netgear WiFi range extender is not updated to the latest firmware version then also you may face the Netgear Genie continually appearing issue. To get rid of this, update the device to the most recent firmware version by accessing its settings.
Usually, if there is any new firmware version available for the extender model you have, you will get an alert for the same. Just by clicking on the alert notification also you can update the firmware of your extender.
